Page 6 of 24
Setup
WELL STX 180 User Manual Rev. 1
Wireless Operation
In optimal conditions, the WELL STX 180 can operate up to 300 m (900 ft) away from the W-DMX TRX
transmitter. The W-DMX receiver in the WELL STX 180 must be paired with the W-DMX TRX transmitter
for wireless operation.
Initial Setup
1. Turn the W-DMX TRX transmitter on.
2. Connect the W-DMX TRX transmitter to a DMX controller.
3. Place the WELL STX 180 within 300 m from the W-DMX TRX transmitter.
4. Turn the WELL STX 180 on.
Configuration
1. From the WELL STX 180 control panel, go to
DMX Address
.
2. Select the start address, as with any other DMX compatible product.
3. Go to
Wireless Setting > Operating Mode
.
4. Select
Receive
.
5. Go to
Wireless Setting > W-DMX On/Off
.
6. Select
On
. (The Signal Strength Indicator will show a
?
in front of the bars).
7. Press the reset button on the W-DMX transmitter. (The Signal Strength Indicator on the
WELL STX 180 will show a
ϟ
in front of the bars for 3 seconds while a connection is established.).
Product Pairing
If the WELL STX 180 has already been paired with the W-DMX TRX transmitter, the Signal Strength
Indicator in the middle of the LCD screen will show the strength of the signal. In this case, the
WELL STX 180 is ready to work in wireless mode.
To pair the WELL STX 180 and a new W-DMX transmitter, follow the instructions below:
1. From the WELL STX 180 control panel, go to
Wireless Setting > Receive Reset
.
2. Select
Yes
. The Signal Strength Indicator on the WELL STX 180 will show a
?
in front of the bars.
3. From the W-DMX transmitter, press
<RESET>
(the Signal Indicator on the transmitter will flash).
4. Once the transmitter has found the WELL STX 180, the Signal indicator on the W-DMX transmitter
will illuminate solid.
5. The Signal Strength Indicator in the middle of the LCD screen on the WELL STX 180 will show the
strength of the signal.
Master/Slave Connectivity
The Master/Slave mode allows an WELL STX 180 (the master) to control one or more WELL STX 180
products (the slaves) without a DMX controller. One WELL STX 180 becomes the master when running an
auto program, or by being in Static mode.
You must configure each slave’s control panel to operate in Slave mode. During Master/Slave operation,
the slaves will operate in unison with the master.
Once a WDMX receiver has been linked to a specific W-DMX TRX transmitter, it will remain
linked to that specific transmitter until it is linked to a different one.
W-DMX operation can be interrupted or inhibited by liquid masses between the transmitter
and receiver. For best results, keep the area between the transmitter and receiver clear of
any liquid mass.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX
controller signals may interfere with the signals from the master.
• The
section of this manual provides detailed instructions on how to
configure the master and slaves.
• If you are not familiar with or need more information about DMX standards, or the DMX
cables needed to link this product to a DMX controller, download the DMX Primer from
the Chauvet website:
.
Содержание Well STX 180
Страница 1: ...USER MANUAL...
