Chattanooga Group OptiFlex, Руководство пользователя

Страница: 9 / 20

OPTIFLEX USER MANUAL 8
complete, the Comfort Zone ™ Flexion Angle will be increased by one
degree each consecutive cycle until it reaches the currently
Programmed Flexion Angle.
Note: If
COMFORT ZONE
is pressed within 30 degrees of the currently
Programmed Extension Angle, treatment will stop and the message
"Comfort Zone Too Small" will be displayed.
Mode: Used together with
FAST BACK
™
, OSCILLATION ZONE
™
and
PROGRESSIVE ROM
button to enable and disable the appropriate mode.
All three modes or any combination may be used at once.
How to Use: Press
MODE
button along with desired function
(FAST BACK,
OSCILLATION ZONE
and/or
PROGRESSIVE ROM)
.
Fast Back
™
: When the carriage reaches 15 degrees less than the
Programmed Flexion Angle, it will begin to slow down. The deceleration
rate will be half of the Programmed Speed when the carriage comes
within 10 degrees of the flexion angle. Upon reaching the flexion angle,
the carriage will reverse direction and resume the Programmed Speed
as it moves towards the extension angle.
How to Use: While pressing and holding the
MODE
button, press the
FAST
BACK
button to enable the
FAST BACK
mode
Note: If both
FAST BACK
and
OSCILLATION ZONE
modes are enabled, the
carriage will move at the slower of 75°/min and half of the Programmed
Speed while in the
OSCILLATION ZONE ROM
.
WARNING
If pain is severe, do not use Comfort Zone. Stop treatment
immediately. Failure to do so could result in tissue damage
and could compromise surgical repair.
Non-Working ROM
Fast Speed
Fast Speed
Working ROM
(10°)
Slow Speed
Fast Speed
Working ROM
Speed = 60°/min.
FAST BACK
F = Programmed Flexion Angle
E = Programmed Extension Angle