Chattanooga Group OptiFlex, Руководство пользователя

Страница: 8 / 20

OPTIFLEX USER MANUAL 7
Up Arrow: Increases treatment parameters in conjunction with other
buttons.
How to use: Select the specific function to increase
(SPEED, EXTENSION,
FLEXION or EXTENSION/FLEXION DELAY)
. While pressing and holding the
appropriate button, use the
UP ARROW
to increase the value of the
specified function.
Down Arrow: Decreases treatment parameters in conjunction with other
buttons.
How to use: Select the specific function to increase
(SPEED, EXTENSION,
FLEXION or EXTENSION/FLEXION DELAY)
. While pressing and holding the
appropriate button, use the
DOWN ARROW
to decrease the value of the
specified function.
Reset: Resets all parameter and patient counters to factory defaults.
How to Use: To reset patient compliance counters, press and hold lightly
by inserting a paper clip and accept reset by pressing the
MODE
button.
To display total unit run time and cycles, press and hold
RESET
for 3
seconds, the total unit time and cycles are temporarily displayed.
Emergency Stop/Start: Starts or stops the treatment.
How to Use: Press the
START/STOP
button to begin or end the treatment.
Comfort Zone ™ : Temporarily decreases the flexion
ROM
when discomfort
is experienced during treatment.
How to Use: Press and the carriage will immediately reverse direction to
move toward the extension angle. For the next five cycles, the carriage
will operate in a range five degrees less than the angle where the button
was pressed. The Comfort Zone Flexion Angle is five degrees less than
the angle where the button was pressed. Once five cycles are
CAUTION –
Emergency Stop/Start
When unit is stopped and STOP/START button is pressed,
the unit will immediately begin moving in the opposite
direction of the last movement.
C = Comfort Zone activated temporary flexion limit established.
5° = Five degrees less than the angle where Comfort Zone was
activated.
Upon completion of five cycles, ROM will increase by one
degree each cycle until it reaches P.
P = Programmed Flexion angle.
S = Start/Finish.
COMFORT ZONE