THIS STEP IS OPTIONAL, THE CABINET CAN BE
MOUNTED WITH THE REAR PANEL ATTACHED
1
STEP 1. DETERMINE WHICH SIDE THE CABINET WILL HINGE FROM. THE
CABINET IS SHOWN WITH THE HINGE ON THE LEFT SIDE, INVERT THE
CABINET IF YOU WANT THE HINGE ON THE RIGHT SIDE.
STEP 2. UNLOCK THE REAR FRAME AND OPEN IT TO GET ACCESS TO
THE HINGE BOLT NUTS.
STEP 3. REMOVE THE CENTER BOLT FROM THE BOTTOM HINGE ONLY.
LOOSEN THE OTHER TWO BOLT NUTS ON THE BOTTOM HINGE. DO
NOT REMOVE OR LOOSEN THE BOLTS ON THE TOP HINGE.
STEP 4. SLIDE THE BOTTOM HINGE PIN UP UNTIL THE LOOSENED
BOLTS REACH THE END OF THE SLOT. REMOVE THE REAR FRAME BY
MOVING THE BOTTOM OF THE FRAME TO THE REAR AND THEN
DOWNWARD TO DISENGAGE IT FROM THE TOP HINGE PLATE.
REMOVING REAR PANEL FROM CABINET
THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO
CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE
OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT
AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
INSTALLATION
INSTRUCTIONS,
CUBE-IT+ CABINET
IIS-711890, SHEET 1 OF 4 - INSTALLATION INSTRUCTIONS, CUBE IT CABINET - 1:4 - 1-28-03 - ISS. 6 - CPI/BK
A
DETAIL A
REMOVE CENTER NUT FROM
INSIDE THEN REMOVE BOLT
SLIDE HINGE PIN UP
TO END OF SLOTS
LOOSEN NUTS FROM
INSIDE, DO NOT
REMOVE BOLTS
