THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO
CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE
OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT
AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
INSTALLATION
INSTRUCTIONS,
CUBE-IT+ CABINET
IIS-711890, SHEET 4 OF 4 - INSTALLATION INSTRUCTIONS, CUBE IT CABINET - 1:5 - 1-28-03 - ISS. 6 - CPI/BK
A
RUBBER GROMMETS (FOUR PROVIDED) CAN
BE INSTALLED IN LARGEST KNOCKOUT HOLE.
SLIT GROOVES WITH KNIFE TO ALLOW CABLE
PASS THROUGH
THE DOOR CAN BE HINGED FROM EITHER SIDE OF THE CABINET.
1. REMOVE THE FOUR SCREWS AND NUTS FROM THE HINGES.
2. TURN THE DOOR OVER.
3. REINSTALL THE SCREWS AND NUTS ON THE OPPOSITE SIDE.
1/2" AND 3/4" CONDUIT KNOCKOUTS
THE 1/2" MUST BE PUNCHED OUT FROM THE INSIDE
THE 3/4" MUST BE PUNCHED OUT FROM THE OUTSIDE
2" AND 2 1/2" CONDUIT KNOCKOUTS
THE 2" MUST BE PUNCHED OUT FROM THE INSIDE
THE 2 1/2" MUST BE PUNCHED OUT FROM THE OUTSIDE
DETAIL A
USE COMBINATION OF SLOTS
TO GET DESIRED RAIL DEPTH
MOUNTING EQUIPMENT RAIL
MOUNTING RAIL DEPTH CAN BE ADJUSTED BY
REMOVING NUTS AND MOVING THE RAIL TO
THE DESIRED POSITION. USE A COMBINATION
OF ONE OF THE TWO SLOTS ON THE RAIL AND
ONE OF THE SLOTS ON THE SIDE PANELS.
4
