THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO
CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE
OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT
AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
INSTALLATION
INSTRUCTIONS,
CUBE-IT+ CABINET
IIS-711890, SHEET 2 OF 4 - ASSEMBLY INSTRUCTIONS, CUBE IT CABINET - 1:4 - 1-28-03 - ISS.6 - CPI/BK
16.00
31.87 FOR 36" HIGH CAB
44.12 FOR 48" HIGH CAB
19.62 FOR 24" HIGH CAB
MOUNTING REAR PANEL TO WALL
STEP 1. INSURE THAT THE WALL OR MOUNTING SURFACE HAS
SUFFICIENT STRENGTH TO SUPPORT THE CABINET AND
THE EXPECTED CABINET PAYLOAD. THE MOUNTING
SURFACE MUST ALSO BE FLAT AND EXTEND BEYOND THE
TOP, BOTTOM, LEFT, AND RIGHT EDGES OF THE REAR PANEL.
STEP 2. DRILL 11/64" PILOT HOLES FOR THE FOUR 1/4-10 X 2" LAG
SCREWS TO THE DIMENSIONS SHOWN ON THE DRAWING OR
USE THE MOUNTING TEMPLATE PROVIDED.
THE SCREWS SHOULD GO DIRECTLY INTO THE WALL STUDS.
STEP 3. INSTALL THE LAG SCREWS INTO THE HOLES. THE SCREW HEAD
SHOULD PROTRUDE ABOUT 3/8" FROM THE WALL.
STEP 4. MOUNT THE REAR FRAME TO THE WALL BY HOOKING
THE KEYHOLES OVER THE SCREWS. TIGHTEN THE
SCREWS SECURELY.
STEP 5. INSTALL THE REMAINING 2 LAG SCREWS IN THE HOLES
BELOW THE TOP TWO KEYHOLES.
2
MOUNTING KEYHOLES
SCREWS SHOULD
PROTRUDE 3/8"
3/4" PLYWOOD
BACKBOARD
WALL STUDS 16"
ON CENTER
THE REAR FRAME MUST BE SECURED TO WALL USING
ALL 6 LAG SCREWS PROVIDED. THE SCREWS ARE
INTENDED TO GO THROUGH 3/4" PLYWOOD
BACK-BOARD AND THEN INTO WOOD WALL STUDS.
FOR MASONRY SURFACE, THE INSTALLER MUST
PROVIDE APPROPRIATE HARDWARE.
NOTE:
INSTALL 2 LAG SCREWS IN HOLES
BELOW TOP KEYHOLES AFTER THE REAR
FRAME HAS BEEN MOUNTED TO WALL
