Tighten the 90 degree set screw until it makes
contact with the underside of the table
Check the setting by tilting the blade away from
90 degrees and then gently back until it stops.
Check the angle again, if it is correct, secure
this setting by tightening the lock nut.
Adjust against underside of table
Lock Nut
90 Degree Set Screw
Move the blade to the 45 degree position.
Repeat the process, using the 45 degree set
screw which locates against the head of
another screw.
Adjust against this screw
Lock Nut
45 Degree Set Screw
Maintenance
Replacing the Saw Blade
Disconnect the saw from the power supply.
Undo the blade crown guard bolt and remove it.
Fully lower the blade.
Remove the table insert plate.
Raise the blade to its maximum height.
Hold the outer blade flange stationary with the
smaller open-ended spanner.
Use the other spanner to remove the arbor nut.
Note:
The Arbor Nut has a normal, right hand
thread.
Ensure the replacement blade is the correct size;
Blade Diameter
254mm (10”)
Blade Bore 16mm (5/8”)
Blade Thickness (Kerf) 2.8mm
Remove the worn blade and fit the replacement,
ensuring that it is correctly seated on the arbor.
Ensure the teeth are facing downwards at the
front of the saw table.
Refit the parts removed earlier.
