The width of cut is set using the red line on the
scale reader.
Check the setting by moving the rip fence up to
the saw blade and locking the fence in place.
The scale should now read zero.
If the scale requires any adjustment undo the
screw on scale reader and slide the Perspex
piece until the scale is set.
Loosen this screw to adjust the scale reader.
Dust Extraction
It is strongly recommended that a suitable dust
extractor or vacuum cleaner is used at all times.
Failure to do so will lead to a build-up of
sawdust inside the machine. When this
happens it will need to be stripped down and
cleaned out to prevent poor performance.
42mm Diameter Dust Extraction Outlet
Setting Controls
Overload Reset Switch
The saw is equipped with Overload protection.
This will automatically stop the saw if it is
overloaded.
To reset, disconnect the power supply and
allow the motor to cool for approximately five
minutes, then press the button. The On-Off
switch can now be operated as normal.
ON-OFF Safety Switch
The saw is fitted with a safety switch which will
prevent it restarting unexpectedly in the event of
an interruption in the power supply.
Always ensure that the blade guard is correctly
fitted before starting the machine and never
stand directly in front of the blade. Wait until the
blade has reached full speed before starting to
cut.
Push the green button to start and the red to
stop.
Warning:
Overheating may be caused
by the
use of an under-sized extension cable, a cable
that is too long or which is wound, or a dull or
misalignment blade. Check for the cause before
restarting the machine.
