Charnwood PT250, Руководство пользователя

Страница: 8 / 16

Starting And Stopping
To turn on, press the green button.
Wait for the knives to reach their maximum
speed of rotation before commencing with
the cut.
The machine is fitted with an NVR (No
Voltage Release) switch.
This type of switch is designed so that if the
machine is disconnected from the mains
whilst running and then reconnected, the
motor will not automatically restart.
Planing Function
Standing with the switch side as the front. The direction of feed is Right to Left.
Fit the extraction hood under the outfeed table and clamp it into place.
Set The Angle Of The Guide Fence
The guide fence can be set to any angle
from 90 to 45 degrees. There are adjustable
pre-set stops for those two positions.
The guide fence is locked and unlocked by
using this locking knob.
Other angles can be set by reading off the
scale.
Set the Depth of Cut
Turn the plastic knob, located on the end of
the infeed table, clockwise to decrease the
depth of cut.
The planning scale shows mm increments
from 0 to 3. (Max. recommended is 2mm
per pass)
As a general rule, set the depth at 1mm
and, if necessary, make 2 or 3 passes until
the desired result is achieved.