Charnwood PT250, Руководство пользователя

Страница: 12 / 16

Place the knife height setting jig on
the out-feed table with the curved
section sitting over the knife and
cutter block.
Using the Hex key, Adjust the blades
if needed so that they just touch the
curved section of the setting jig.
Tighten the 5 locking bar bolts and
ensure it is firmly locked in place.
Repeat these steps for the second
knife. Check that the blades do not
contact the edge of the table.
Troubleshooting
Problem Cause Remedy
Machine does not start Blown Fuse Replace Fuse
Loose switch terminal Inspect back of switch
Faulty switch Replace switch
Guard not fitted Re-fit the plastic guard ensuring
it connects with the interlock
switch
Only starts when Green button
is held down Faulty switch Replace switch
Machine runs intermittently Worn carbon brushes in motor Replace carbon brushes
Motor running but cutter block
is not rotating Broken or stretched drive belt Replace drive belt
Motor slows down during the
cut Depth of cut is too great Take a smaller cut
Dust & Chip collector hood is
blocked Clear the blockage and ensure
the extractor is functioning
correctly
Planing knives are blunt Replace knives
Excess Vibration Planing knives out of balance Reset the height of the knives