Replace by feeding the new belt
through the opening in the lathe bed
and over the bottom pulley, then over
the corresponding upper pulley. Apply
tension and tighten the locking handle.
Ensure that the V- grooves are on the
inside of the belt and engaged with the
grooves on the pulleys.
Replacing the Motor Brushes
The carbon brushes should be regularly
inspected and will need changing after
approximately 500 hours use, or when the
block has worn down to a length of 7mm.
Unscrew the two black plastic screws found
on either side of the motor.
Withdraw the worn brush and spring, then
replace it with a new one.
Always
replace both brushes at the same
time.
Содержание 1420V
Страница 16: ...Charnwood 1420V Wiring Diagram ...
Страница 19: ...Charnwood 1420V Parts Drawing ...