Adjusting the Spindle Speed
The lathe has electronic speed
control. There are three ranges of
speeds which are obtained by
changing the position of the drive
belt.
To adjust the drive belt position:
1) Remove the bottom pulley
access door by first loosening the
four pozi-head securing screws.
Then raise and lift off the door.
2) Open the upper belt cover by
first loosening the retaining screw
with a 3mm hex key. An
alternative knurled head screw is
supplied with the lathe, but this
should not be fitted if the lathe is
being used within the European
Union.
Содержание 1420V
Страница 16: ...Charnwood 1420V Wiring Diagram ...
Страница 19: ...Charnwood 1420V Parts Drawing ...