Charlton & Jenrick 2000 Plus Extra Remote, Руководство пользователя

Страница: 7 / 32

7 LT
6312 (ISS 3)
Warning:- This appliance has a naked flame, has with all fires it is recommended that a fireguard should be used
for the protection of children, the elderly and infirm.
Fireguards should conform to BS 6539 (1984) (fireguards for use with solid fuel appliances).
During the normal operation of the fire some black staining may appear on some parts of the fuel bed. This is
quite normal and adds to the appearance of the appliance. However, if excessive black staining does occur it may
be due to the fuel bed being incorrectly laid. This should be checked against the Fuel Bed Layout in Section Three,
prior to contacting a service engineer.
Pilot Cleaning (Before cleaning ensure that the appliance is turned off and cold)
In some instances you may experience ignition problems even when the
appliance is new. This may be due to the aeration hole in the pilot body (see
photograph) being partial blocked with dust, pet hairs or other foreign matter.
The source of this debris could be such things as carpet fibres, decorating or pets
etc.
To clean the pilot, remove the fire front and ashpan. The pilot is located on the
right hand side of the appliance, any debris in or around the aeration hole
should be removed using the nozzle of a vacuum cleaner. It is advisable not to
blow the debris into the hole as this may cause more of a restriction and not
rectify the problem.
Fret
A Fret must be used with this appliance, and must conform to the following: -

It must be made from non-combustible material.

Its general construction should enable it to stand firmly across the full width of the

burner.

The design of the fire front (fret) must have a removable ash-pan cover (lower section).

The ashpan cover must have cut-outs and or holes which provide ventilation to the underside of the
burner.

The effective area of ventilation through the ash-pan cover must be greater than 1365mm2 (2.12 sq.
ins.)