Charlton & Jenrick 2000 Plus Extra Remote, Руководство пользователя

Страница: 21 / 32

21 LT
6312 (ISS 3)
FIXING FIRE INTO OPENING
Remove the paper backing from the length of foam seal and stick it around the rear flange of fire. If a spacer is going
to be used stick the second length (supplied with the spacer kit) around the rear face of the spacer unit, THE FOAM
SEAL MUST BE POSITIONED TO ENSURE AN AIR TIGHT SEAL WHEN THE APPLIANCE IS FITTED.
NOTE: -DO NOT USE PERAMENT SEALING COMPONDS i.e. SILICON SEALANT. THIS COULD CAUSE THE
APPLIANCE TO BE DAMAGED WHEN IT IS REMOVED FOR SERVICING, AND COULD INVALIDATE THE
WARRENTY.
If the spacer is not being used, mark position of flange hole in the fireplace front drill and fix firebox in position with
wall plugs and wood screws. If spacer is being used fix the spacer to the fireplace first with wood screws and wall
plugs then screw firebox to spacer box using screws provided.
OPTIONAL CABLE FIXING SYSTEM (Available on request from PARAGON FIRES)
(for use when fixing to 18" openings or when it is
desirable not to drill the fireplace fascia) it may not
be possible to use the cable fixing system with
some pre-cast flues.
Drill 4 holes in the rear of the fireplace opening in
the position shown and fix securely the 4 eye bolt
provided with suitable wall plugs
Fix the fire casing back into the opening using
the cable fixing system as shown in do not
cut off loose ends of cable after fixing, coil
and tuck carefully behind sides of Refractory
back
Note: when using the cable fixing kit with the
spacer, fix and seal the spacer to the rear of the
appliance flange with the screws and foam seal
provided.
260mmCRS.
30mm
460mm
FIX 4 OFF EYE
BOLTS IN
POSITIONS SHOWN
TENSIONING NUT
CLAMP SCREW