C6050A, C6050B
v2.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~15S LiPo/LiFe battery
1~55Amps 3050W max.
www.chargery.com
page
10
total
19
Program Setup
1.
In charger idle interface, press
knob
button for 2 seconds enter
into Program Setup menu.
2.
LCD display the following information in sequence and you can
modify its value. When you want to alter a parameter value, press
the
knob
button make the value blink then modify the value by
rotate the
button. The new value will be confirmed and saved by
pressing the button again. Press
knob
buttons alternate different
items, and press
knob
to quit the setup menu.
Note:
All parameters will be remembered by the C6050 till next change.
Picture 3
Program setup
Setup the Temperature unit,
℃
or
℉,
default
℃
.
Temp. Unit
--->
℃
Setup the maximal charge current on power supply mode, range from
1A~55A, step 0.1A, default 55A. It is only active for power supply.
Max current
---> 55A
Setup the fan starting temperature, range from 30~50
℃
,
step 1
℃
,
default 35
℃
.
The fan speed will increase with the temperature go
Fan ON Temp.
---> 40
℃
The beeper sounds for each button press to confirm your action. These
sounds can be ON or OFF. Default ON.
Buzzer
--->
ON
This menu sets the back-light time of LCD screen backlight.
Options:
1MIN, 5MIN, 10MIN, 20MIN and Always on, default 5MIN.
At
default 5min, LCD back-light will be off to save the power,
press
knob
resume the back-light.
BACK-LIGHT TIME
---> 5MIN
Setup over temperature protection, range from 70~90
℃
,
step 1
℃
,
default 90
℃
.
Over the temperature, the charger will power off
Shut Down Temp.
---> 80
℃
Software Version
C6050A or B V2.0
