Charger HydroSplash CWISO475CHPL, Инструкция для владельца и по установке

Страница: 8 / 24

– 4 –
2.3 Connecting the feed water supply (Figure 3)
The feed water assembly consists of 1/2” brass slip joint adapter, a black
washer, and a 1/4" x 1/4" ball valve. Locate these parts in the installation kit.
Locate the cold water shut off valve under the sink and turn it off. Open the
cold water faucet to release the pressure. On single handled faucets, the hot
water may have to be turned off to prevent any hot water cross-over. If water
continues to come out of the faucet with the under-sink valves turned off, the
house main valve will have to be turned off.
With the water turned off, disconnect the cold water riser tube (flex line) from
the valve. Install the slip joint connector with the black washer. Loosen the
nut and separate the cold riser tube from the faucet shank. Gently bend the
riser tube so that the slip joint adapter fits onto the faucet shank. Reinstall the
cold riser tube on the slip joint connector using the existing cone washer. For
Solid copper tube the procedure is the same except you must cut a piece
of the riser tube about 3/4” to 1” so the slip joint adapter can fit between the
valve and the riser tube. Wrap several turns of Teflon tape on the ball valve and
install on the slip joint connector.
Figure 3
Ball Valve
Existing Cold Water
Line to Sink
Rubber Grommet
1/2" Slip Joint Adapter
Black Washer
Existing Cold Water Supply Valve
1/4" Tubing (orange)
Nut