11
Burner, Firebox and Control Knobs
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24 x ½"
machine screws. Insert two #10-24x1-1/4” screws from outer firebox, then fasten with two #10-24 flange nuts and 5x15
fiber washers from inner. Repeat on the other side
(A)
.
Place firebox onto upper firebox supports. Make sure the venturi tubes are located underneath heat shield. Make sure
venturi tubes are correctly engaged. If burner is not leveled from left to right, adjust the two screws attaching valve to
control panel. Attach ignitor wire to ignitor
(B)
.
Attach firebox with #10-24x1/2" screws, 5x15 fiber washers and #10-24 flange nuts
(C)
.
Push control knobs onto valve stems
(C)
.
A
Burner Assembly
Control Knob
#10-24 Flange nut
#10-24X1/2”
Machine Screw
5x15
Fiber Washer
C
Make sure the Venturi tubes are located
underneath Heat Shield
Valve
Venturi tube
Ignitor wire
Heat Shield, F/ Tank
Firebox
5x15 Fiber Washer
#10-24X1/2”
Machine Screw
5x15 Fiber washer
#10-24
Flange nut
#10-24x1-1/4”
Machine Screw
Qty. 4
5x15
Fiber Washer
Qty. 10
#10-24
Flange Nut
Qty. 8
#10-24X1/2”
Machine Screw
Qty. 6
#10-24x1-1/4”
Machine Screw
B
22
