8
•
Before each use, check to see if hoses are cut or worn or
kinked. Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
Hose Check
• Important: Make sure gas is off at LP cylinder before
checking valves
. Knobs lock in off
position. To check valves,
first push in knobs and release, knobs should spring back. If
knobs do not spring back, replace valve assembly before using
grill. Turn knobs to
LOW position then turn back to off position.
Valves should turn smoothly.
Valve Check
• Turn gas off at LP cylinder.
Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time in
each collector box or between burner and electrode. See
"Troubleshooting"
if no click or spark.
Ignitor Check
• Turn all knobs to the
off
position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
• Remove cooking grates and heat tents. Light burners, rotate
knobs from HIGH to LOW. You should see a smaller flame in
LOW position than seen on HIGH. Perform burner flame check
on side burner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden drop or low flame" in
the
Troubleshooting
Section.
HIGH
LOW
Burner Flame Check
Sideburner Ignitor Lighting
•
Do not lean over grill while lighting.
4.
Turn sideburner knob to the
HIGH position, push and hold
ELECTRONIC IGNITOR
button.
5.
If sideburner does NOT light within 5 seconds, turn knob
to off, wait 5 minutes, then repeat lighting procedure.
Sideburner Match Lighting
4.
Place lit match near burner. Immediately turn sideburner
knob to the HIGH position. Be sure burner lights and stays
lit.
NOTE: Your grill may NOT be equipped with a
Sideburner!
Storing Your Grill
• Clean cooking grates.
• Store in dry location.
• When LP cylinder is connected to grill, store outdoors in a
well-ventilated space and out of reach of children.
•
Cover grill if stored outdoors. Choose from a variety of grill
covers offered by Char-Broil at charbroil.com.
• Store grill indoors ONLY if LP cylinder is turned off and
disconnected, removed from grill and stored outdoors.
• When removing grill from storage, follow “
Cleaning the
Burner Assembly
” instructions before starting grill.
2. Open lid during lighting or re-lighting.
•
Do not lean over grill while lighting.
3. Turn ON gas at LP cylinder.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
1. Turn gas burner control valves to (off).
SEAR Burner Ignitor Lighting
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
1. Turn gas burner control valves to (off).
•
Do not lean over grill while lighting.
4. To ignite, push and turn SEAR burner knob to HIGH.
Immediately push and hold
ELECTRONIC IGNITOR
button until
the burner lights.
5.
If ignition does NOT occur in 5 seconds, turn the burner controls
off , wait 5 minutes and repeat the lighting procedure.
SEAR Burner Match-Lighting
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
1. Turn gas burner control valves to (off).
•
Do not lean over grill while lighting.
4. Place match into match holder (hanging from side panel of
grill). Light match; then light burner by placing match through
the match light hole on side of grill. Immediately
push in and
turn SEAR burner knob to the
HIGH position. Be sure
burner lights and stays lit.
Turning Grill Off
