8 • 4632236
FIGURE 6
15. Secure grill head to all cart legs using 4 of the 1/4x2-1/2"
Phillips-head screws and 1/4" nuts. See Fig. 6.
16. Fully tighten all leg screws, rear panel screws, door
bracket screws, and grill head screws.
17. From the back of the cart, slide the grease draining tray into
the grill head. Place the grease receptacle into the notches
on the bottom of the tray. See Fig. 6.
Grease
draining
tray
Grease
receptacle
Attach grill head
to all 4 legs
Contact
Spring
AA Battery
18. Unscrew the ignitor cap located on the control panel and
remove the contact and spring from the ignitor slot.
See Fig. 7.
19. Place the supplied AA battery into the ignitor slot with the
positive pole facing toward you.
20. Place the spring with contact over the battery. Screw the
ignitor cap back onto the control panel.
FIGURE 7
Ignitor
cap
+
–
22. Attach trim plate to front of left shelf by placing top lip of
plate ABOVE bottom lip of shelf. Secure using three
3/16"x3/8" Phillips-head screws and 3/16" nuts.
Fully Tighten. See Fig. 9.
Plate lip
Shelf
lip
FIGURE 9
21. Thread the L-shaped fitting on regulator onto the manifold.
Be sure the regulator is pointing down, then wrench-tighten
the connection. See Fig. 8.
FIGURE 8
Regulator
L-shaped
fitting
Manifold