30 V DC
+
-
0
1
2
2
3
4
5
6
7
UP
DOWN
PROG
LEARN
(YELLOW)
INDICATOR
LED
1
2
3
4
5
6
7
1
.
External Accessory Power:
30 Vdc 50 mA available for universal receiver (not active in Low standby mode).
2. Terminal Block:
used for external accessories (see chart below).
3. UP Button:
used for initial programming, to drive the door UP, and for displaying Diagnostic Code - Digit 1.
4. PROG Button:
used to program door limits, and other features.
5. DOWN Button:
used for initial programming, to drive the door DOWN, and for displaying Diagnostic Code - Digit 2.
6. LEARN Button:
used to program remote controls and learn the forces manually.
7. Indicator LED:
used to indicate various programming modes.
No
Function
Colour
Polarity
Comment
0
E-Serial port
Green
+ve
Serial Communication Input
1
Push button
Red
+ve
Dry Contact input for push button wired wall controls
2
Ground
White
-ve
Common terminal for push button
2
Ground
White
-ve
Common terminal for IR Beams
3
IR Sensor
Gray
+ve
Chamberlain IR Beam Input: (pulsing type only)
4
Door-in-door
Green
+ve
For Door in Door dry contact sensor: (4&5 are normally linked)
5
Door-in-door
Green
-ve
Common terminal for Door in Door sensor
6
Flasher
Black
+ve
Flashing light output: (24 Vdc 150 mA) while door is in motion
7
Flasher
White
-ve
Flashing light output: negative terminal
CONTROL PANEL (located under the cover at the rear of the opener)
5
7
