Chamberlain WLED, Руководство пользователя

Страница: 16 / 55

)NSTALLATION
(ANG THE 'ARAGE $OOR /PENER
4O AVOID POSSIBLE 3%2)/53 ).*529 FROM A FALLING GARAGE DOOR OPENER FASTEN IT 3%#52%,9 TO
STRUCTURAL SUPPORTS OF THE GARAGE #ONCRETE ANCHORS -534 BE USED IF INSTALLING !.9 BRACKETS INTO
MASONRY
(ANGING YOUR GARAGE DOOR OPENER WILL VARY DEPENDING ON YOUR GARAGE 4WO REPRESENTATIVE
INSTALLATIONS ARE SHOWN 9OURS MAY BE DIFFERENT (ANGING BRACKETS SHOULD BE ANGLED &IGURE TO
PROVIDE RIGID SUPPORT /N FINISHED CEILINGS &IGURE ATTACH A STURDY METAL BRACKET TO STRUCTURAL
SUPPORTS BEFORE INSTALLING THE OPENER 4HIS BRACKET AND FASTENING HARDWARE ARE NOT PROVIDED
-EASURE THE DISTANCE FROM EACH SIDE OF THE MOTOR UNIT TO THE STRUCTURAL SUPPORT
#UT BOTH PIECES OF THE HANGING BRACKET TO REQUIRED LENGTHS
$RILL Ñ PILOT HOLES IN THE STRUCTURAL SUPPORTS
!TTACH ONE END OF EACH BRACKET TO A SUPPORT WITH Ñ X Ñ LAG SCREWS NOT PROVIDED
&ASTEN THE OPENER TO THE HANGING BRACKETS WITH Ñ X Ñ HEX BOLTS LOCK WASHERS AND
NUTS
#HECK TO MAKE SURE THE RAIL IS CENTERED OVER THE DOOR OR IN LINE WITH THE HEADER BRACKET IF THE
BRACKET IS NOT CENTERED ABOVE THE DOOR
2EMOVE THE X /PERATE THE DOOR MANUALLY )F THE DOOR HITS THE RAIL RAISE THE HEADER BRACKET
./4% $/ ./4 CONNECT POWER TO OPENER AT THIS TIME
FIGURE 1
FIGURE 2
(Not Provided)
Lag Screws
5/16"- 18x1-7/8"
Measure
Distance
Hex Bolt 5/16"- 18x7/8", Lock Washer 5/16", Nut 5/16"-18
FIGURE 3
Not Provided
Finished Ceiling
Unfinished Ceiling
Hex Bolt 5/16"- 18x7/8" Nut 5/16"-18 Lock Washer 5/16"
HARDWARE