)NSTALL THE $OOR #ONTROL
)NSTALL THE $OOR #ONTROL
4O PREVENT POSSIBLE 3%2)/53 ).*529 OR $%!4( FROM ELECTROCUTION
z
"E SURE POWER IS ./4 CONNECTED "%&/2% INSTALLING DOOR CONTROL
z
#ONNECT DOOR CONTROL /.,9 TO 6/,4 LOW VOLTAGE WIRES
4O PREVENT POSSIBLE 3%2)/53 ).*529 OR $%!4( FROM A CLOSING GARAGE DOOR
z
)NSTALL DOOR CONTROL WITHIN SIGHT OF GARAGE DOOR OUT OF REACH OF SMALL CHILDREN AT A
MINIMUM HEIGHT OF FEET M ABOVE FLOORS LANDINGS STEPS OR ANY OTHER ADJACENT
WALKING SURFACE AND AWAY FROM !,, MOVING PARTS OF DOOR
z
.%6%2 PERMIT CHILDREN TO OPERATE OR PLAY WITH DOOR CONTROL PUSH BUTTONS OR REMOTE
CONTROL TRANSMITTERS
z
!CTIVATE DOOR /.,9 WHEN IT CAN BE SEEN CLEARLY IS PROPERLY ADJUSTED AND THERE ARE NO
OBSTRUCTIONS TO DOOR TRAVEL
z
!,7!93 KEEP GARAGE DOOR IN SIGHT UNTIL COMPLETELY CLOSED .%6%2 PERMIT ANYONE TO
CROSS PATH OF CLOSING GARAGE DOOR
).42/$5#4)/.
#OMPATIBLE WITH MY1
AND 3ECURITY ACCESSORIES SEE PAGE 9OUR GARAGE DOOR OPENER IS
COMPATIBLE WITH UP TO 3MART #ONTROL 0ANELS OR OF ANY OTHER 3ECURITY DOOR CONTROLS
./4%
/LDER ,IFT-ASTER DOOR CONTROLS AND THIRD PARTY PRODUCTS ARE NOT COMPATIBLE
)NSTALL DOOR CONTROL WITHIN SIGHT OF GARAGE DOOR OUT OF REACH OF SMALL CHILDREN AT A MINIMUM HEIGHT OF
FEET M ABOVE FLOORS LANDINGS STEPS OR ANY OTHER ADJACENT WALKING SURFACE AND AWAY FROM !,,
MOVING PARTS OF DOOR &OR GANG BOX INSTALLATIONS IT IS NOT NECESSARY TO DRILL HOLES OR INSTALL THE DRYWALL
ANCHORS 5SE THE EXISTING HOLES IN THE GANG BOX
./4%
9OUR PRODUCT MAY LOOK DIFFERENT THAN THE ILLUSTRATIONS
HARDWARE
Screw
6AB x 1" (2)
Drywall
Anchors (2)
Screw
6-32 x 1" (2)
3TRIP Ñ MM OF INSULATION FROM ONE END OF THE WIRE AND SEPARATE THE WIRES
#ONNECT ONE WIRE TO EACH OF THE TWO SCREWS ON THE BACK OF THE DOOR CONTROL 4HE WIRES CAN BE
CONNECTED TO EITHER SCREW
02%7)2%$).34!,,!4)/.3
#HOOSE ANY TWO WIRES TO CONNECT NOTE WHICH WIRES ARE USED
SO THE CORRECT WIRES ARE CONNECTED AT THE GARAGE DOOR OPENER IN A LATER STEP
-ARK THE LOCATION OF THE BOTTOM MOUNTING HOLE AND DRILL A Ñ HOLE
)NSTALL THE BOTTOM SCREW ALLOWING Ñ MM TO PROTRUDE FROM THE WALL
0OSITION THE BOTTOM HOLE OF THE DOOR CONTROL OVER THE SCREW AND SLIDE DOWN INTO PLACE
,IFT THE PUSH BAR UP AND MARK THE TOP HOLE
2EMOVE THE DOOR CONTROL FROM THE WALL AND DRILL A Ñ HOLE FOR THE TOP SCREW
0OSITION THE BOTTOM HOLE OF THE DOOR CONTROL OVER THE SCREW AND SLIDE DOWN INTO PLACE !TTACH
THE TOP SCREW
7/16" (11 mm)
Wall
1
2
3
DRYWALL
GANG BOX
6AB x 1"
6-32 x 1"
Drywall Anchor
4-5
6
6-32 x 1"
GANG BOX
8
DRYWALL
6AB x 1"
Drywall Anchor
7
Содержание WLED
Страница 5: ...0REPARATION 4OOLS EEDED 3 16 5 32 5 16 7 16 1 2 5 8 9 16 1 4 7 16...
Страница 55: ......