12
21
WIRELESS PROGRAMMING (REMOTE ACCESSORIES)
NOTE: The transmitters supplied with your opener are preprogrammed by the factory.
If you purchase additional transmitters, wireless wall
controls and keypads the garage door opener must be
programmed to accept the new remote code.
Program the receiver to match additional transmitter
codes:
Using the “S” SAVE Button
1.Press and hold the button on the remote, wireless wall
control that you wish to use (1)
2.Press and release the “S” button on the opener (2)
3.Release the remote button when the courtesy light
flashes twice. It has learnt the code. If you release the
remote control push button before the opener light
flashes, the opener has not learnt the code.
The opener will now operate when the remote control button is pressed.
To Erase all Remote Control Codes
1.Press and hold the “S” button on the opener until the courtesy light flashes twice, and continue holding for
approximately 8 seconds, until the courtesy light flashes twice again.
2.Release the button, all codes are now erased.
1
2
Flash x 2
BEEP
DN
DN
UP
UP
P
P
S
S
1
1
2
2
3
3
or
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave the garage while the door is in motion. Do not allow children to
operate push buttons or remotes. Do not allow children to play near the door.
PROGRAM DOOR MONITOR 829EV
Using the S button on the garage door opener
1.Connect power to the door monitor.
Position the door monitor in a convenient location inside
the house.
If this place is too far from the gate opener the connection
may not be possible or is often interrupted.
Choose a more convenient place.
2.Press and release the “LEARN” button on the back of the
door monitor. Red and green LED blink alternately.
Within 60 seconds press and release the S button on the
garage door opener.
To confrim programming red and green LED on the door
monitor are on.
DELETE DOOR MONITOR
1.Press the “LEARN” button on the back of the door monitor for
at least 10 seconds.
A short beep confirms that deleting was successful.
NOTE: to use the CLOSE button function on the door monitor
you also need to connect the safety photocells, 770E or
771EVK.
Flash x 2
BEEP
DN
DN
UP
UP
P
P
S
S
1
1
2
2
3
3
