9
Handle should be
less than 1.8 m
<
1
.8
m
Once you have completed your installation and
successfully carried out the safety reverse system
test (outlined above), install the warning labels
provided with your opener as shown.
The risk of entrapment label must be installed
adjacent to the release handle at a height of less than
1.8 m from the floor.
The WARNING label must be installed in a prominent
place near any fixed control.
Any fixed wall control or wireless door control must be
mounted at a height of no less than 1.5 m out of the
reach of children.
Read the safety instructions (page 1) for further
details concerning safety.
FIXING WARNING LABELS
Operate the door in the down direction. The door must
reverse upon contact with the obstacle. If the door
stops on the obstacle, remove obstacle and repeat
limit and force setting (refer to section 14).
Repeat the safety reverse system test.
15
40 mm Test obstacle
40 mm
16
TESTING THE SAFETY REVERSE SYSTEM
After installing the operator on the door, the
force measurement of the operator must be
checked according to EN13241/EN12543
with a force measurement device and an obstacle
detection test must be performed.
STANDARD INSTALLATION COMPLETE
INSTALLING YOUR 128EV WIRELESS WALL BUTTON
To install:
• Carefully pry open the 128EV and locate the two screws for
mounting.
• Attach to the wall using the two screws and wall anchors
provided if mounting to a plaster wall. If using a recessed wall
box do not use anchors.
NOTE: Do not overtighten screws.
+
17
Disconnect power to the opener whilst installing
this accessory to prevent accidental activation.
Locate minimum 1.5 m above the floor
NOTE: The wall control supplied with your opener should be pre-programmed by the factory.
If adding a new wall control, program into the opener before mounting the unit as detailed in
the “Wireless Programming” in section 21.
