Model 15000-3S & 15000-SPRINTER
Installation, Operation and Maintenance
Page
6
Rev. 8/13/19
15-3S-IOM-A.doc
14) Install Overhead Limit Switch to the Overhead
Beam using the rear set of holes on the Power
Side of the lift.
Fig. 5.
Fig. 5 – Overhead Limit Switch Power Side
15) Install the Idler Bracket to the Overhead Beam
using the rear set of holes on the Idler Side of
the lift.
Fig. 6. Note the orientation of the Idler
Bracket. The narrow slot needs to be facing
towards the Power Column.
Slide the Shutoff
Bar over the limit switch on the Power Side. Pin
the Shutoff Bar to the Idler Side Bracket with the
10mm dia. x 55mm Lg. clevis pin & hairpin
cotter.
Fig. 6 –
Overhead Bracket Idler Side
16) Assemble the cable trapping hardware with a
3/8”-16 x 3” Lg bolt with (2) 3/8”-16 flange nuts at
each upper sheave location. For the lower
sheaves, use a 3/8”-16 x 3/4" Lg. bolt and a 1/4"
dia. x 1 3/4" Lg. clevis pin (
Fig. 7
). At the upper
and lower sheave connections, disassemble and
reassemble the cable trapping hardware.
BASE PLATE
OVERHEAD
BASE PLATE
OVERHEAD
BASE PLATE
OVERHEAD
BASE PLATE
OVERHEAD
Fig. 7 – Cable Trapping
