Challenge TITAN 265 XG, Руководство оператора

Страница: 18 / 52

5.0 Installation & Setup
18
NOTE: The terminal block jumper must be set to the correct location according to the supply voltage
of the machine. Failure to set the terminal block jumper will cause damage to the machine!
The power source is connected to the cutter at in the junction box located at the rear, right hand side
of the machine.
5.7.1 Single Phase Hook-Up
1. Disconnect the power at the main power panel and lock it out to prevent accidental power-up.
See Power Lock-Out procedure, page 5.
2. Thread the power cord through the knock-out hole in the junction box located near the floor in
the lower left hand corner of the machine rear. Secure it with a conduit connector.
3. Fasten the ground lead to the ground terminal lug found in the junction box.
4. Use wire nuts to join the two power leads to the L1 and L2 leads found in the junction box.
5. Close all doors and guards, unlock the main power and switch it on. The machine should
now have power.
5.7.2 Three Phase Hook-Up
1. Disconnect the power at the main power panel and lock it out to prevent accidental power-up.
See Power Lock-Out procedure, page 5.
2. Thread the power cord through the knock-out hole in the junction box located near the floor in
the lower left hand corner of the machine rear. Secure it with a conduit connector.
3. Fasten the ground lead to the ground terminal lug found in the junction box.
4. Use wire nuts to join the three power leads to the L1, L2 and L3 leads found in the junction
box.
5. Close all doors and guards, unlock the main power and switch it on. The machine should
now have power.
6. Press both cut buttons simultaneously to activate the motor and check to make sure it is
turning the same direction as the arrow on the motor casing. If it isn’t, disconnect the power
and simply exchange any two leads of the power cord as in Figure 14 on page 18. The motor
will now turn the correct direction. Double check to make sure.
Figure 14
1
2
3 1 2
3