APR 2018
CMT-330TC Three-Knife Trimmer
2-4
2. Installation Guide
6. Turn down the leveling pads and raise the
elevator until the top shelf is 36-1/32" (91.5
cm) from the floor as shown in Figure 2-8.
Figure 2-8. Elevator Height Setting
7. Align the elevator with the infeed conveyor
and attach as shown in Figure 2-9 using the
hardware provided.
Figure 2-9. Elevator Attachment to
Infeed Conveyor
8. On the trimmer, adjust the height of the in-
feed bracket (Figure 2-10) if necessary. The
flat, horizontal surface of the bracket should
be
1/32” (1mm) below the trimmer's infeed
conveyor belt.
Figure 2-10. Infeed Bracket
9. Move the trimmer into position against the
elevator, aligning the mounting brackets on
the elevator to the corresponding holes in
the side of the trimmer. Once the trimmer
height is set properly according to Section
2.5 Trimmer Height Setup, attach the eleva-
tor to the trimmer using supplied mounting
hardware (Figure 2-11).
Figure 2-11. Elevator Attachment to Trimmer
Cable and Air Tubing Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
elevator near the input connectors. The
power cables are the larger diameter cables
with 7-pin connectors on the end.
2. Route the power cable under the hydraulic
unit and out of the left side of the trimmer.
3. Connect the power cables as shown in Fig-
Figure 2-12. Power Cable Connections
4. Now locate the yellow communication cable
coiled up inside the trimmer that is labelled
with the number that corresponds to the la-
bel on the elevator near the input connect-
ors. It is a small diameter cable with a 3-pin
connector on the end. Also locate any sepa-
rate communication cables that were sup-
plied with the infeed/outfeed options.
5. Connect the communication cables as
shown in Figure 2-13.
Содержание CMT-330TC
