Cordless Grass Trimmer
ORIGINAL INSTRUCTIONS
Cordless Grass Trimmer
ORIGINAL INSTRUCTIONS
1. Guard installation(FIG. C1, C2)
1). Remove two screws from the motor
housing.
2). Slide guard over motor housing.(Figure C1)
3). Re-insert two screws into the guard and
tighten.(Figure C2)
C1 C2
2. Attach front handle (FIG. D)
1). Turn the handle knob and draw out the bolt
from the front handle.
2). Insert the front handle in the machine
handle.
3). Insert the bolt and handle knob, then turn
the handle knob lightly tighten.
4). Before tightening completely, turn the front
handle in desired angle. When front handle
is in desired angle, tighten the handle knob
securely.
D
ASSEMBLY INSTRUCTIONS
OPERATION(FIG. E)
Grip rear handle and press trigger lock-off
button (A) with thumb then pull trigger switch (B).
(See Figure E)
E
STARTING
1. Before starting the grass trimmer for the first
time, check that the nylon lines touch or pass
over the wire cutting blade. If they are not long
enough,
1). press the button,
2). pull more nylon wire to lengthen.(Figure F1)
2. The lengthened nylon line will be cut to size
automatically by the wire cutting blade once the
lawn trimmer is turned on.
3. During use, the nylon line will become
shortened or worn. To automatically lengthen
or advance the nylon cutting line, tap the
spool button lightly on ground (while the unit is
running).(Figure F2)
F1 F2
4. The length of the grass trimmer can be
infinitely varied and therefore adjusted to your
individual height (Figure G):
1). Hold the tube with one hand, then loosen the
adjusting bolt.
2).Set the handle to the correct length and
Front handle
I
5. Making sure to insert the spring, assemble
the spool and spool carrier back onto the
trimmer. To do so, push the head on and turn it
clockwise until it locks. You will hear a "click".
(Figure J)
J
6. To test if the line is advancing properly, push
the button with your thumbs while pulling the
wire with your fingers. The line should advance
freely.
OPTION 1: ACCESSORY REPLACEMENT
SPOOL
Use replacement spool.
OPTION 2: REWINDING SPOOL USING
LINE
Line for your trimmer is available at extra cost
from your local dealer. To install line, follow
the steps below (Use 1.6mm diameter round
Nylon line only).
1. Insert one end of line into the hole in the
spool as shown Figure K about 3 mm.
tighten the adjusting bolt.
G
REPLACE THE SPOOL OF
NYLON LINE
1. Switch off the trimmer and wait for all parts
to stop moving.
2. Remove the battery.
3. Remove the spool assembly from the
trimmer. To do so, hold the outer ribbed part
of the assembly with one hand, while pushing
down and turning the spool head with the
other to unlock it (Figure H). The spool carrier
and spool will now disassemble easily.
Note:
There is a spring inside the head that
could easily be lost. Ensure that it is put in a
safe place.
H
3. Choose either OPTION 1 or OPTION 2
below for spool or line replacement.
4. Insert the line through the eyelet in the
spool carrier and slide the spool into it. (Figure
I)
Tube
Adjusting
bol t
