HELPLINE NO 08454 505299
10
ORIGINAL INSTRUCTIONS
1) Inserting the blade
Only use saw blades with a T-shank. (see fig.1)
2) Removing blade
3) Dust extraction
The jigsaw is equipped with a suction device
so that the dust and chips can be extracted.
Insert the dust port into the rear of the jigsaw.
This is done by inserting the port (4) with the
two tabs in the grooves located on the jigsaw
and turning it counterclockwise to lock it in
place. Remove the device by turning it
clockwise and pull it from the device. Attach
the dust extraction hose to the port of a
suitable vacuum cleaner.
4) Using the Parallel Guide
The parallel guide can only be used
for work pieces with a maximum
thickness of 30 mm.
For parallel cuts, first you will need to fix the
guide (17) as follows:
• Remove the locking screws (15) and insert
the scale of parallel guide through the
guide (16) in the bottom plate.
• Select the desired cutting width by
positioning the guide using the scale value
on the guide.
• Fix the position by tightening the locking
screws (15).
• This jigsaw has an automatic eject function
on the quick release chuck.
• Hold the saw so that the saw blade (13)
points towards a protected area (work
surface or wall). Do not point in the direction
of other people.
• Turn the quick release chuck (11) clockwise,
the spring mechanism of the chuck will eject
the blade automatically.
• Turn the quick-action chuck (11) lever and
keep it turned. Place the blade in the chuck
so it locates in the roller guide (8).
• Push the required saw blade (13) up to the
stop .The saw blade (13) should click into
place.
• Let go of the quick-action chuck lever: the
lever should return to its original position
automatically locking the saw blade in place.
If the lever does not return to its
original position the blade is not
positioned correctly and requires
pushing further into the chuck.
CAUTION!
To prevent personal injury,
always disconnect plug from power
source before assembling parts, making
adjustments, or changing blades and
observe the general safety guidelines.
ASSEMBLY
WARNING!
Blades can get very hot
during use. Avoid direct contact with
the saw blade and let it cool down first.
1
2
