Challenge Xtreme BMS210MS.1, Оригинальное руководство пользователя

Страница: 9 / 20

HELPLINE NO 08448012949
9
OrIgINaL INstructIONs
2. tabLE EXtENsION raIL (see b1)
To install table extension rail, simply insert
ends of extensions into the holes in either
or both sides of the base. Secure them in
place by tightening clamp screw on the
base.
The table extension rail is used for
supporting the long pieces.
Fig. B1
3. suPPOrt staNd (see fig.b2-b4)
Loose the screw (a1) from the base.
Insert ends of support stand (2) into the
holes in the back of the base plate and
tighten the screw on the base as shown
in fig.b2&b3&b4.
warNINg:always assemble the
support stand when using the
product.
Fig. B2
2
Fig. B3
a1
OPEratINg INstructIONs
NOtE: Before using the tool, read the
instruction book carefully.
INtENdEd usE
The electro-tool is intended as a stationary
machine for making straight lengthways and
crossways cuts in wood. Horizontal mitre
angles of -45° to +45° as well as vertical
bevel angles of 0° to +45° are possible.
assEMbLy
warNINg:
To prevent the accidental
starting that could cause possible
serious personal injury, ALWAYS assemble
all parts to your saw BEFORE connecting
it to the power supply. The saw should
NEVER be connected to a power supply
when you are assembling parts, making
adjustments, installing or removing blades,
or when not in use.
1. dust EXtractION POrt (see a)
Fig. A
To reduce build up of saw dust and maintain
top efficiency of cutting, the saw dust
collection can be achieved by clipping a
dust bag on the dust extraction port.
A dust bag is provided for use on your miter
saw. To install it, simply fit the dust bag
over the extraction port on the upper blade
guard.
To empty the dust bag, remove it from the
dust exhaust port, open the dust bag by
unzipping the slide fastener.
NOtE: To ensure optimal dust collecting,
empty the dust bag when it becomes filled
to approximately 2/3 of its capacity.