Challenge Xtreme BMS210MS.1, Оригинальное руководство пользователя

Страница: 3 / 20

HELPLINE NO 08448012949
3
OrIgINaL INstructIONs
that keys and adjusting wrenches are
removed from the tool before turning it
on.
17 - Avoid unintentional starting
- Ensure switch is in “off” position when
plugging in.
18 - Use outdoor extension leads
- When the tool is used outdoors, use
only extension cords intended for
outdoor use and so marked.
19 - Stay alert
- Watch what you are doing, use
common sense and do not operate the
tool when you are tired.
20 - Check damaged parts
- Before further use of tool, it should be
carefully checked to determine that it
will operate properly and perform its
intended function.
- Check for alignment of moving parts,
binding of moving parts, breakage
of parts, mounting and any other
conditions that may affect its operation.
- A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service centre unless
otherwise indicated in this instruction
manual.
- Have defective switches replaced by an
authorized service centre.
- Do not use the tool if the switch does
not turn it on and off.
21 - Warning
- The use of any accessory or attachment
other than one recommended in this
instruction manual may present a risk of
personal injury.
22 - Have your tool repaired by a qualified
person
- This electric tool complies with the
relevant safety rules. Repairs should
only be carried out by qualified persons
using original spare parts, otherwise
this may result in considerable danger
to the user.
addItIONaL safEty INstructIONs
fOr yOur baNd saw
1. safety precautions
Do not use saw blades which are
damaged or deformed;
Replace the table insert when worn;
Connect band saw to a dust-collecting
device when sawing wood;
Do not operate the machine when the
door or guard protecting the saw band is
open;
Take care that the selection of the saw
band and the speed depends on the
material to be cut;
Do not clean the saw band whilst it is in
motion;
Wear suitable personal protective
equipment, when necessary, this could
include:
- Hearing protection to reduce the risk of
induced hearing loss;
- Respiratory protection to reduce the risk
of inhalation of harmful dust;
- Gloves for handling the saw band and
rough material.
2. safe operation
1) When straight cutting against the fence
use a push stick;
2) During transportation the saw band
guard should be fully down and close to
the table;
3) When bevel-cutting with the table
inclined, place the guide on the lower
part of the table;
4) When cutting round timber use a suitable
holding device to prevent twisting of the
workpiece;
5) Lifting and transportation positions shall
clearly be indicated on the tool;
6) Do not use guarding for handling or
transportation;
7) Adjust the adjustable guard as close to
the workpiece as practicable;
8) Adjust the guard as close as possible to
the piece to be cut;