Challenge Xtreme BMS210MS.1, Оригинальное руководство пользователя

Страница: 14 / 20

HELPLINE NO 08448012949
14
OrIgINaL INstructIONs
red line.
Switch off the laser after cutting.
Note: The sawdust may “block” the laser
beam, clean the laser generator periodically.
warNINg: Never stare directly into
the laser beam and never point the
beam at anybody.
daNgEr: Laser radiation. Avoid
direct eye contact with light source.
Fig. L2
20
MaINtENaNcE
warNINg: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.
when all the adjustments, settings or
maintenance have been done, make sure
that all keys and wrenches have been
removed and that all screws, bolts and
other fittings are securely tightened.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working
controls free of dust. Occasionally you may
see sparks through the ventilation slots.
This is normal and will not damage your
power tool.
If the supply cord of this power tool is
damaged, it must be replaced by a specially
prepared cord available through the service
organization.
1. PrEcIsION sEttINg Of aNgLEs
(see M1-O2)
While the machine has been factory set, it
is advisable that the 0
°
setting of the rotary
table and the 90
°
perpendicular setting of
the tilt be checked, as these positions may
have moved in transit. (Ensure power
is disconnected while making these
adjustments).
To confirm the 0
°
rotary table setting, set the
rotary table at 0
°
and tighten the rotary table
locking knob. Check that the angle between
the straight guide and the blade is 90 ° using
a try square (g, not supplied) as shown in
Fig.M1. If the angle requires adjustment,
loosen the locking screws (h) for straight
guide, and align the fence against the try
square.
Re-tighten the locking screws (h) for straight
guide.
Similarly, check that the angle of the blade
to the face of the rotary table is 90
°
. If
necessary, adjust the tilt angle of the saw
head at the 90
°
position by adjusting the set
screw (i) for 90
°
(See N1, N2)
Fig. M1
g
Fig. M2