Challenge Xtreme BMS210K.1, Руководство пользователя

Страница: 9 / 16

HELPLINE NO 08707252949
9
4. MOUNTING HOLES (SEE C)
Fig. C
Before use, the saw can be fixed to a firm,
level surface with the 4 mounting bolts (Not
supplied).
Four mounting holes are provided in the
base of the saw to enable it to be fixed to a
bench, or other supporting surface.
To mount the saw, proceed as follows:
1) Locate and mark where the saw is to be
mounted.
2) Drill 4 holes through the surface.
3) Place the sliding miter saw on the surface
aligning holes in base with holes drilled in
the surface. Install bolts, washers and hex
nuts.
5. WORK CLAMP (SEE D)
The work clamp can be fitted on either side
of the saw and is fully adjustable to suit the
size of the workpiece.
Do not operate the saw without clamping
the workpiece.
Make sure that the work clamp securing
screws are tightened.
Fig. D
24
OPERATION
1. TO MAKE A CUT
1. When boxed or during storage,
transportation, the saw head is locked in the
down position. To release the head ready
for operation, apply downward pressure and
pull out the lock pin (20).
2. Connect the machine to power outlet
ensure that the mains cable is clear of the
blade and base plate.
3. Position the material to be cut on the
machine bed, ensure it is firmly held so that
it will not move during cutting.
Ensure that the rotary table locking knob
(13) and bevel lock knob (22) are tightened
before cutting.
4. Press the trigger switch and allow the
saw blade to run up the speed.
5. Still holding in the trigger switch, press
the safety release lever (16) towards the
handle. It will then be possible to push the
saw head down by the handle.
6. Continue to move the saw head down
smoothly and make the cut exerting only
gentle pressure on the downward stroke,
letting the saw do the work.
2. MITER CUTS (SEE E)
A miter cut is made at 0º bevel and any
miter angle in the range from 45º left to 45º
right.
20
13
Fig. E
Release the rotary table locking knob (13).
Move the saw to the desired angle by
twisting so that the table turns. Set at the
desired angle, and tighten the rotary table
locking knob. Make your cut.