HARDWARE:
M5x10mm Screw
M6x15mm Bolt
M6x40mm Bolt
M6 Nut
1/4-20
Thumb
Screw
B
B
C
C
D
D
C
D
E
E
A
A
Figure A:
(L.P. Gas Models Only)
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Attach the drawer slides (58) to the tank holder (57)
using four M5 screws (A) as shown. Ensure that the ends
of the drawer slides are flush with the front of the tank
holder. Loosely tighten the screws.
Attach the tank drawer assembly (from step 1) to
the bottom panel (47) using four M6 bolts (B) as shown.
Insert the thumb screw (E) into the tank holder (57)
as shown. It does not need to be tightened at this time.
Align two legs (48) to the corners of the bottom
panel (47) as shown. The side panel (49) wraps around the
outside of the legs.
From the back side of the assembly, insert one M6
bolt (C) through the side panel (49), leg (48) and bottom
panel (47), and thread a M6 nut (D) to the bolt (C) from the
inside. Loosely tighten the bolt.
From the front side of
the assembly, insert two M6
bolts (C) through the right
door mount (55), then
though the
s
s
Loosely tighten the screws. Once all screws are in place
from steps 1 and 2, tighten them securely.
side
panel (49), leg (48) and
bottom panel (47), and
thread M6 nut (D) to the
bolt (C) from the inside.
Loosely tighten the bolts.
Repeat Step 6 for
the left side panel, legs, and
door mount (52)(see index page 34).
The door mounts are specific to left
and right - the item shown (55) is for
the right side. The legs and side panels
are not specific to left and right.
Figure B:
Step 7:
58
57
47
47
55
48
48
49
Figure A
(L.P. Gas
Models
Only)
Figure B
Front
Back
10