-22-
PRO
PILOT
725 INSTALLATION & SERVICING MANUAL
Installation
Settings
INSTALLATION SETTINGS
There
are
four
installation
settings
which
are
as
follows:
•
Rudder
phasing
of
the
Rudder
Feedback
Unit.
•
Motor
phasing.
•
Rudder
Feedback
Unit
offset.
•
Magnetic
Compass
offset
for
all
compatible
compass
units.
Note:
These settings are not available if the Distribution Box has
software earlier than V7.0.
To access the settings, turn the Autopilot Control ON using the
following sequence:
S P E C I A L
While holding down the key, turn the unit ON by pressing
the ON/ST'BY key then release the ON/ST'BY key but keep the
key held while the unit cycles through the start up and self
check routines until the LCD displays “SPECIAL”. The unit is
now in Special Function mode.
Once you are in Special Function mode, the SEA STATE key
allows you to step through the Installation settings.
Rudder
This selects which signal from the Rudder Feedback Unit
Phasing
indicates Port and which indicates Starboard movement of the
rudder.
RUDPHA A
The
first
press
of
the
SEA
STATE
key
brings
up
the
Rudder
Phasing
message.
The
right
hand
digit
will
be
an
A
or
B
depending on which phasing has been selected. Press either the
or key to change the phasing. There is no need to change
any wiring.
Motor Phasing
This
selects
which
direction
the
motor
drives
so
that
the
rudder
moves
to
Port
and
Starboard
correctly.
MOTPHA A
The
second
press
of
the
SEA
STATE
key
brings
up
the
Motor
Phasing
message.
The
right
hand
digit
will
be
an
A
or
B
depending on which phasing has been selected. Press either the
or key to change the phasing.
