![Cessna skylance tc T182T Скачать руководство пользователя страница 287](http://html1.mh-extra.com/html/cessna/skylance-tc-t182t/skylance-tc-t182t_information-manual_2584574287.webp)
CESSNA
SECTION 7
MODEL T182T NAV III
AIRPLANE AND SYSTEM DESCRIPTION
GFC 700 AFCS
U.S.
LIGHTING SYSTEMS
(Continued)
INTERIOR LIGHTING
(Continued)
Avionics panel lighting consists of the PFD and MFD bezel and display
lighting and Audio Panel lighting. Rotating the AVIONICS dimmer,
found on the switch panel in the DIMMING group, controls the lighting
level. Positioning the dimmer control in the off position (fully
counterclockwise) causes the avionics displays to use internal
photocells to automatically control the lighting levels. This is the
recommended use of the avionics lighting for all day and lower lighting
levels where lighting of the avionics bezels and keys is not required. In
low to night lighting levels rotating the AVIONICS dimmer control
clockwise from the off position places all avionics lighting level control
to the AVIONICS dimmer control. This is the recommended use of
avionics lighting for night and low lighting conditions to allow the pilot
control of the avionics illumination levels as dark adaptation occurs.
Rotating the STBY IND dimmer, found on the switch panel in the
DIMMING group, controls lighting of the standby airspeed indicator,
attitude indicator, altimeter, non-stabilized magnetic compass, and
overhead oxygen console. Rotating the dimmer counterclockwise
decreases light intensity from the highest level to off.
Pilot's chart (map) lighting is accomplished by use of a rheostat and a
light assembly, both found on the lower surface of the pilot's control
wheel. The light provides downward illumination from the bottom of the
control wheel to the pilot's lap area. To operate the light, first turn the
NAV light switch ON, and then adjust the map light intensity using the
knurled rheostat knob. Rotating the dimmer clockwise (when facing up)
increases light intensity, and rotating the dimmer counterclockwise
decreases light intensity.
Regardless of the light system in question, the most probable cause of
a light failure is a burned out bulb. However, in the event any lighting
systems fails to come on, check the appropriate circuit breaker. For the
interior lights the PANEL LTS circuit breaker, and for the exterior lights
the associated light function circuit breaker (i.e. landing light, LAND LT
circuit breaker). If the circuit breaker has opened, and there is no
obvious indication of a short circuit (smoke or odor), turn the affected
lights OFF, reset the circuit breaker, and turn the lights ON again. If the
circuit breaker opens again, do not reset until maintenance has been
performed.
T182TPHBUS-00
7-71
Содержание skylance tc T182T
