SECTION 4
CESSNA
NORMAL PROCEDURES
MODEL T182T NAV III
GFC 700 AFCS
U.S.
STARTING ENGINE (With External Power)
(Continued)
18. Mixture Control - SET to FULL RICH (full forward) until stable
fuel flow is indicated (approximately 3 to 5 seconds), then set to
IDLE CUTOFF (full aft) position.
19. FUEL PUMP Switch - OFF
20. MAGNETOS Switch - START (release when engine starts)
21. Mixture Control - ADVANCE SMOOTHLY TO RICH (when
engine starts)
NOTE
If the engine is primed too much (flooded), place the
mixture control in the IDLE CUTOFF position, open the
throttle control 1/2 to full, and engage the starter motor
(START). When the engine starts, advance the mixture
control to the FULL RICH position and retard the throttle
control promptly.
22. Oil Pressure - CHECK (verify oil pressure increases into the
GREEN BAND range in 30 to 60 seconds)
23. Power - REDUCE TO IDLE
24. External Power - DISCONNECT FROM GROUND POWER
(latch external power receptacle door)
25. Power - INCREASE (to approximately 1500 RPM for several
minutes to charge battery)
26. AMPS (M BATT and BATT S) - CHECK (verify charge shown
(positive))
27. LOW VOLTS Annunciator - CHECK (verify annunciator is not
shown)
28. Internal Power - CHECK
a.
MASTER Switch (ALT) - OFF
b.
TAXI and LAND Light Switches - ON
c.
Throttle Control - REDUCE TO IDLE
d.
MASTER Switch (ALT and BAT) - ON
e.
Throttle Control - INCREASE (to approximately 1500 RPM)
f.
M BATT Ammeter - CHECK (verify battery charging, amps
positive)
g.
LOW VOLTS Annunciator - CHECK (verify annunciator is
not shown)
(Continued Next Page)
T182TPHBUS-00
4-14
Содержание skylance tc T182T
