U100.5.0
18
4.2.2 Associating a Handheld Using the Virtual Unlock Process
Note
:
Associating a new transmitter using Virtual Unlock can only be done from a transmitter
that is already associated to the receiver.
This process unlocks association for
five
minutes, allowing the user to associate another
handheld to the receiver. Once association is complete
—or five minutes have passed—the
RECEIVER will return to a locked state.
Note
:
The target receiver must be powered.
1. Turn on the handheld by pressing the STOP button.
2. Wait for the RX/TX LED to begin blinking rapidly.
3. Press and hold buttons A/B Aux1, AUX2, and then STOP.
Receiver will sound the horn and activate the Association relay to confirm the receiver is now
unlocked The handheld then powers down.
4. Go to Section 4.3.
4.3
Associate a Handheld to a Receiver
This process is required when the handheld memory slot is either empty or the
user wishes to associate to a different receiver.
Note:
During this process, a receiver that is in use with another handheld
cannot be associated.
1. Turn on the handheld by pressing and releasing the
STOP
button.
2.
Within 1 second,
while the
B Select LED
is active,
simultaneously
press and release buttons A/B and AUX 2.
Handheld LEDs will begin cycling indicating the handheld is in maintenance
mode.
3. Simultaneously press and hold buttons 3 (UP) and 4 (DOWN) for approximately five
seconds.
4. Release the buttons when
LED A
starts blinking.
5. TX/RX LED and
B Selection LED
become active, indicating the handheld is attempting
to locate all available Warrior receivers.
6. Once the handheld has completed its search
—and one or more receivers have been
found
—the
TX/RX LED
and
A Selection LED
become active.
If there are no receivers available, the handheld stays in scan mode until the handheld times out
or is turned off.
7. A detected receiver starts blinking the association LED indicator, and the Horn/Light
relay engages to sound the horn. To select this receiver, press button AUX 2. The
TX/RX LED starts blinking rapidly, indicating communication is established. The receiver
ID is now stored in the handheld memory slot.
8. If the found receiver unit is
NOT
the receiver desired, press the A/B AUX 1 button to
scroll through the detected receivers until the desired receiver is found. (It is the one
blinking its association LED indicator and pulsing its Horn/Light relay that sounds the
horn.) Press button AUX 2 to select the receiver. The TX/RX LED starts flashing rapidly,
Содержание Warrior MU-9X15
Страница 1: ...2019 Cervis Inc MU X15 System Manual U100 4 0...
Страница 12: ...U100 5 0 8 Figure 5 MU 9X15 Mounting Dimensions...