Cervis Warrior MU-9X15, Системное руководство

Страница: 21 / 31

System Manual
©
2019 Cervis, Inc.
17
4.0
Warrior MU-X15 System Operation
4.1
System Startup
The following assumes that power is applied to the Warrior
MU-9X15 receiver.
1. Press the handheld STOP button (B1).
2. Wait while the LEDs cycle and then the RX/TX LED
begins flashing.
3. Press the Horn/Start button (B2). This energizes the
MLC relays in the receiver.
The handheld is ready for normal functional operation.
4.2
Associating a Handheld with a Receiver
Warrior MU-X15 system handhelds are associated with the receiver before the system is
shipped; and the Association process is locked by DIP switch 8 in the receiver being 0 (OFF).
The receiver only communicates with handhelds it is associated with. When necessary, other
Warrior handhelds can be associated with the receiver as additional spares or to replace
damaged handhelds,
but the receiver’s association ability must be unlocked first.
There are two methods to unlock association:
1. By manually changing the position of DIP switch 8 in the receiver. To unlock
Association, DIP Switch 8 must be changed from its default position (0 [OFF]) to
(1 [ON]). Unlocking with the DIP switch unlocks association until DIP switch 8
changes back to the 0 (OFF) or LOCKED position.
2. By using an already associat
ed handheld and preforming a “virtual” UNLOCK.
This process allows users to unlock the receiver from a distance without needing
to access the receiver. A virtual unlock allows users to associate with the locked
receiver for a limited time; after five minutes
—or after a successful handheld
association
—the virtual unlock expires, and the receiver becomes locked again.
4.2.1 Associating a Handheld Using the DIP Switch Unlock Option.
This process will unlock association of the receiver allowing the user to associate handhelds to
the receiver until the DIP switch is set back to the locked position.
1. Set the receiver SW01 DIP Switch 8 ON (UP).
2. If the receiver is Off , the Horn/Light relay will activate when it is powered. If the receiver
is On , the Horn/Light relay will immediately activate.
3. Go to section 4.3
Cervis, Inc. does not recommend leaving receivers in an
UNLOCKED state. Move DIP switch 8 to the “0” (OFF) position
once association is complete.
1
3
2