The build process continued
STEP 53
Push the top of the liner into the top groove of the liner-lock.
STEP 54
Continue pushing the liner into the liner-lock all around the
pool and then push out the creases with your feet.
Do not wear shoes for this procedure.
STEP 55
When the water reaches the lower suction point, cut a small cross by feeling the
centre of the hole and pressing the liner against the fitting. Pierce the liner with
a pen where the screw holes are for the clamp plate. Cut the 4 segments to
create a round hole, the same diameter as the middle of the fitting.
STEP 56
Fit the plastic clamp plate with the screws provided. Tighten
the screws evenly across opposites to create a good seal.
Tip:
It may help to have some water in the pool
to help pull the liner into position.
Please note:
Do not cut the hole too big
STEP 57
Fit the low suction cover plate grill. Carry on filling the pool
underneath the level of the return inlets. Work around the pool
floor moving any creases in the liner outwards.
STEP 58
Cut the holes for the return pool water jets. Fix the screw on
plates again tightening the screws evenly to create a good
seal.
