Priming
The Aquaspeed pump will prime and re-prime providing the hair and lint pot bowl is full of water and there is
sufficient supply from the suction point.
If you lose water from the hair and lint pot bowl it will be necessary to refill it before starting.
1. Remove the clear lid and fill the hair and lint pot bowl with water
2. Replace the lid ensuring
the o-ring is correctly
located and start the pump
After you have done this allow a
maximum of 2 minutes
for the pump to start delivering water.
WARNING
High suction lift or long suction lines will require additional time to prime and can severely affect the performance of the pump.
If the pump will not prime (flow) repeat steps 1 and 2 above.
WARNING
If allowed to run dry, mechanical seals can be damaged rapidly and may need to be replaced.
ENSURE
that there is always adequate water in the hair and lint pot bowl before you commence start up.
If you are unable to prime the pump please see the trouble-shooting guide.
Ensure
all suction and discharge valves
are open before you start the pump, operating the pump with these valves shut can
damage the pump.
