Cersanit AirMATIC, Инструкция по установке и эксплуатации

Страница: 46 / 126

46
INST
ALLA
TION
AND OPERA
TION MANUAL
BA
THTUB WITH MASSAGE SYSTEM
EN
The structure and low adhesion of the acrylic surface makes the bathtub easy to clean. After finishing the massage, the ba-
thtub should be rinsed with water and wiped with a moistened cloth. From time to time thorough cleaning of the appliance
is also required. Then a liquid cleaning agent for acrylic surfaces must be used. Never use scrubbing agents! The lime de-
posit must be removed by means of warm lemon juice or wine vinegar with water. Cleaning agents containing the following
substances containing must not be used for cleaning the bathtub: chlorine, acetone, ammonia, nitro compounds, alcohol,
abrasive or caustic substances. In order to remove small scratches and surface fogging, a light buffing compound should
be used. Bathtub disinfection must be carried out at least once a month or after every 10 baths. The user must activate the
appliance and add a suitable disinfectant to the water circulation. After approx. 5 minutes the water must be drained, the
bathtub refilled with clean water and water circulation elements must be rinsed.
8 BATHTUB MAINTENANCE
9 REPAIRS AND TYPICAL TROUBLESHOOTING
Problem Possible cause Means of correction
Bathtub does not work Power supply interrupted Check bathtub system electrical
connections
Water pump is active even though
the bathtub is empty
Water level sensor damaged (applies
to bathtubs equipped with the
system protecting the water system
from “dry” operation)
Contact the service centre
Low water pressure in nozzles Deposits of impurities in the water
system
Clean water system ducts and disin-
fect the system
Bathtub creaks while filling it with
water
Improperly adjusted feet Adjust the feet so that the bathtub is
properly levelled and rests evenly
on all four feet
Bad smells coming from the bathtub Improper disinfection procedure, lack
of drain trap maintenance
Disinfect the system regularly
Foam is created during bath Improper substances used for
massage
Use only low foaming bathing oils
Bathtub scratched Using improper cleaning agents,
using sharp objects in the bathtub
Remove scratches by means of fine-
grained buffing compound
Halogen light defective Burned out bulb Replace bulb
Light mechanical damage (surface scratches or polished surface abrasions) may be removed by sandpaper (granularity
800, 1200, 2000) and polished with a light buffing compound (used to polish car bodywork).