Cersanit AirMATIC, Инструкция по установке и эксплуатации

Страница: 38 / 126

38
INST
ALLA
TION
AND OPERA
TION MANUAL
BA
THTUB WITH MASSAGE SYSTEM
EN
5.6.4 Multicoloured illumination.
The multicoloured illumination function enhances the user’s visual experience during the massage. In order to activate the
illumination, the following conditions must be fulfilled:
- bathtub must be filled with water up to a given level,
- the bathtub must not be equipped with the white illumination system,
- automatic disinfection function must be deactivated.
Fulfilling the above conditions makes it possible to activate the lamp in the following manner:
1 press activates multicoloured illumination and enables the function which changes the illumination
colour periodically .
2 press deactivates the function of periodical illumination colours change.
3 press deactivates multicoloured illumination.
5.6.5 Water heating.
The water heating function is used to maintain water temperature at a preset level. To this end, the bathtub should be filled
with water of temperature closest to the level which is to be maintained.
In order to activate the water heating function, the following conditions must be fulfilled:
- bathtub must be filled with water,
- bathtub must be equipped with the massage water system,
- massage water system must be activated,
- automatic disinfection function must be deactivated.
Fulfilling the above conditions facilitates system activation of the function according to the following procedure:
Press and hold the pushbutton. until the (upper) indicator on the display is lit. Temperature regulator is activated.
Press the pushbutton again causes temperature regulator activation.
5.6.6 Controller error codes.
5 SETS EQUIPPED WITH ELECTRONIC CONTROLLERS
Code on the
display
Code description Error correction procedure.
Er1
Water level too low during automatic disinfec-
tion process
Fill the bathtub up to the required .
level and press the pushbutton .
to cancel the error message
Er2
Cleaning liquid level too low during automatic
disinfection process
Refill the tank and press the .
pushbutton to cancel the .
error.message
Er3
Temperature sensor not connected to the
controller or damaged
Press the pushbutton to .
cancel the error message
Er4
Control panel incorrectly connected to the
controller
Contact the service centre