FibeAir® IP-10C
Installation Guide
Ceragon Proprietary and Confidential
Page 39 of 63
3.3
1+1 HSB Direct Mount Installation
The following components are necessary for a 1+1 HSB direct mount
installation:
Item
Description
Quantity Remarks
I
IP-10C RADIO
2
2
RFU-C COUPLER KIT
1
3
RFU-C TWIST
1
In 1+1 direct mount configuration, the IP-10-C is attached to a coupler.
Important!
Do not remove the transparent pressure window located on
the coupler ports!
To install an IP-10C in a 1+1 HSB direct mount configuration:
Notes:
For 15 and 18 GHz frequencies, two O-Rings are supplied in
the Twist kit and should be mounted in the twist grooves.
For the 6 GHz frequency, a gasket is used instead of an O-
Ring. The gasket should be mounted between the twist and
the RFU-C Coupler kit.
1 Mount the twist to the coupler using the O-Ring and four screws supplied
in the Twist kit, and tighten the screws.
Important:
Make sure the polarization mounting direction of the twist
to the coupler is according to the antenna polarization.
