![CERA-Design RONDOTHERM Скачать руководство пользователя страница 63](http://html1.mh-extra.com/html/cera-design/rondotherm/rondotherm_manual_2583436063.webp)
What if...?
Cleaning and Care
What?
How often?
With w hat?
Remove ash from the stove.
As required, only when cold.
Caution: ash in the combustion
chamber floor must not be removed
completely.
A small ash residue promotes
combustion. CAUTION: always
completely empty the
ash pan
!!).
Remove the ashpan and remove the
remaining ash with an ash shovel and
brush or ash vacuum.
Clear the stove and chimney flue
pipes from soot depositions
After every heating season.
With soot brushes and vacuum
cleaner.We recommend that
maintenance is carried out by a
specialist dealer.
Clean enamelled surfaces.
As required, only when cold.
Wipe with clean water and a soft
cloth.
Clean the glass pane.
As required, only when cold. Before
spraying the glass pane with glass
cleaner, roll up some paper kitchen
roll into a cylinder and place it in the
door frame at the bottom so that no
cleanser can run between the door
frames and the glass.
Spray with stove glass cleaner (e.g.
from CERA-Design) and wipe.
Clean heat exchanger fireclay brick
As required when cold, at the latest
after each heating period.
Brush off the inclined surfaces using a
soot brush through the combustion
chamber from below; if the flue pipe is
connected at the rear take the cover
off if necessary (see installation of
fireclay heat-storing bricks) and clean
from above. Remove any fallen soot
with an ash vacuum.
... the fire doesn’t burn properly?
•
Is the chimney or flue pipe leaking?
•
Is the chimney properly dimensioned? Are the
cleaning vents open or leaking?
•
Is the outside temperature too high?
•
Is a door on another fireplace connected to this
chimney open?
... the room doesn’t get warm enough?
•
Is the heating requirement too high – the stove too
small?
•
Is the firewood too moist?
•
Is the amount of wood added too small?
... the room gets too warm?
•
Is the supply pressure too high?
•
Is the amount of wood added too large?
... smoke comes out when I put fuel on the fire?
•
The stove doors were opened too quickly.
•
The supply pressure is too low.
•
The firewood has not yet burnt sufficiently.
62