©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Sheet 5 of 15
75992NP
03-26-15
Rev. B
5. There is a wide notch on the outside end of both rails which allows pull wire
⑥
to
enter. Use the kink wire method in Figure 4 to feed carriage bolt
①
and spacer
②
through notch on bottom of frame rails.
6. Raise hitch into position over the exhaust and sandwich the heat shield between hitch
and frame rail. Remove pull wires and loosely install conical washer
③
and hex nut
⑤
to the hitch.
7. Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
8. Using the rearmost hole on each side of hitch bracket as a template, drill
17/32‘’
holes through the frame rail. Repeat step 5 to feed the fasteners and secure the
hitch with conical washer
③
and hex nut
⑤
.
9. Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
10. Raise the exhaust back into position.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
CEQUENT
Proper torque is needed to keep the hitch secure to the vehicle when towing.
