©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Sheet 4 of 15
75992NP
03-26-15
Rev. B
1. Lower exhaust by removing (3) rubber isolators as shown in Figure 1. Use
exhaust support stand to prevent damaging muffler.
2.
Remove (1) screw at the fascia center support and carefully push it toward impact
bar as shown in Figure 2. Return (1) screw to owner.
3. Remove heat shield on both sides. Remove (3) screws, (1) plastic plug on both
sides, and (1) plastic clip attaching wiring harness only on driver side.
4.
Trim the tab off heat shield on both sides, as shown in Figure 3. Reinstall the heat
shields without (2) screws which attach to the frame rails on each side. Return (4)
screws to owner
