Centsys Nova Helix, Руководство по эксплуатации

Страница: 16 / 36

page 16 www.centsys.com
7. When the demastered button is released, the receiver will complete the remastering
operation and remaster the button. A single short beep will signal the end of the
operation, confirming to the user that the button has been remastered. The LED will
turn on again at the end of the operation.
8. When jumper J1 is removed, the receiver will exit link learn mode.
4.2.2. Master Learn Remastering
1. To remaster a remote in this mode, start by entering master learn mode. Refer to
steps 1 and 2 in the Learning Additional Transmitters section on page 11.
2. Only buttons that are associated with the channel of the master button that entered
master learn mode can be remastered in this mode.
3. Press and hold a demastered button (associated with the relevant channel - see point
2 above), for a minimum of three seconds to remaster it. If a new button (button
not learned into the system) is pressed in master learn mode for more than three
seconds, it will be learned into the system (refer to the section, Learning Additional
Transmitters on page 11 for more information).
4. The leading edge of the demastered button transaction is acknowledged with a short
beep. This beep occurs irrespective of whether the button is mastered or demastered.
5. While the demastered button is held down within the demastering window (minimum
3s), the LED will flash (64ms on/448ms off) to register that the button transmission is
being received, and that the button is a demastered button. (Refer to Appendix A on
page 30 for a description of the LED and buzzer feedback)
6. Once the demastering period has elapsed (minimum three seconds), the LED will turn
on and the buzzer will provide a single short beep. This serves as visual and audible
confirmation that the receiver has learnt the button being pressed. The LED will turn
on again at the end of the operation.
7. Once remastered, the system transitions back to master learn mode. Further buttons
may be remastered by following steps 3 through 6.
8. If no additional buttons are pressed within the 10s master learn mode period, the
receiver will automatically exit learn mode. This exit is signalled by an extended
single beep. The Status LED will turn off and resume its responsibilities in normal
mode.
4.3. Bulk Demastering
Since all remotes that are added to a receiver are always added with master privileges,
a mechanism has been exposed on the Nova Helix receivers that allows certain groups of
remotes, currently learnt on the receiver, to be demastered simultaneously.
To bulk demaster remotes, follow the procedure highlighted below:
1. Ensure that there is no power on the receiver.
2. If the receiver is a multichannel receiver, place links on the channel jumpers to select
the channel that will be bulk demastered. All the buttons associated with this channel
will be demastered. If all buttons (i.e. buttons associated with any channel) must be
demastered, leave the channel jumpers unlinked. Single-channel receivers always
bulk demaster all buttons because there is only one channel compartment.
TH
E
JUMPER
INTERFA
CE
S
ECTION
4