C. Adding CentSys code-hopping remote controls
To add a CentSys code-hopping remote control to the onboard receiver
and assign a button to any specific function as described on the
previous page, follow the steps below:
FIGURE 33.
FIGURE 34.
Step 1:
Rotate the Function Dial
to the REMOTES position (B).
Step 2:
Rotate the Setting Dial
to the desired selection along
the ‘B’ row of options.
You can choose from the following settings:
Tx TRG to assign a remote control button to be learned into
the system and trigger the gate to fully open
Tx PED to assign a remote control button to be learned into
the system and partially open the gate for a pedestrian
Tx LCK to assign a remote control button to be learned into
the system and activate Holiday Lockout Mode
Step 3
: Press the pushbutton to
select the setting chosen from
above – the status LED will
change from red to green to
confirm the setting.
Step 4:
Press the desired
button on the remote control(s)
that you want to activate the
selected function.
The status LED will flash twice
indicating that the onboard
receiver has learned in the
remote control(s). The onboard
buzzer will also pulse twice.
FIGURE 32.
FIGURE 35.
Step 5:
Return the Function
Dial to the RUN position.
Customising
the
Features
and
Functions
page 20
