Centrosolar TFP 288 Professional, Руководство по установке

Страница: 9 / 16

Wiring Information: TF Plate Professional
When wiring the TF Plate Professional module, please
note that there are two electrically independent laminates
applied to the carrier sheet metal. Structurally, it is one
inseparable unit. Electrically, however, the two laminates
are independent. Therefore, laminate A can be connected
to a different string or inverter than laminate B. Likewise,
both laminates can be connected in series to one string or
one inverter.
Please note that all design programs for inverters refer to
a laminate with a power of 144 W. For an electrical view it
is therefore necessary to consider the number of the lami-
nates (twice the number of modules) and not the number
of modules.
Mounting the cable duct
Apply an approx. 6 mm wide strip of MS polymer adhesive
with a 15 mm distance to the edge of the module carrier
plate. The adhesive strip should begin with an approx. dis-
tance of 25 mm to the long side of the module and should
have a length of 810 mm. One polymer adhesive cartridge
(290 ml) is sufficient for ten to twelve modules. Observe
the manufacturer's processing information of the MS poly-
mer adhesive.
Fig. 14
Position the base plate flush with the outer edge of the
module carrier plate and in the middle of the long sides.
The short side of the base plate faces the top. Apply even
pressure to the base plate until the polymer adhesive is
distributed with a thickness of approx. 1 mm. Slight push-
ing motions in all directions are helpful.
Fig. 15
Please note:
The MS polymer adhesive must set
for 24 hours before any further cable
duct work can be continued.
800 mm
~ 6 mm Ø
15 mm
9
Installation Guide